Install Instructions
5
This manual is intended to familiarize the installer and user of the
Argo AR Series of controls with their installation and operation to
assure normal trouble-free operation.
Argo controls are designed and manufactured with quality compo-
nents for maximum life and durability and require minimal service.
To insure a satisfactory installation, it is imperative that the instruc-
tions be followed carefully before operating the control. Failure to
do so may result in breach of warranty.
INTRODUCTION
MOUNTING INSTRUCTIONS
Mount the Argo AR Series Control vertically on a solid wall or parti-
tion. For your convenience it is recommended that the control be
mounted as close as possible to the device to be controlled. The
control should never be mounted more than 75 feet away. Select a
location that is easily accessible for installation and service.
NOTE: To reduce the possible transformer hum and relay
noise that is sometimes amplied by mounting surfaces
such as sheet metal, plasterboard, and similar materials,
place rubber or felt washers between the case and the
mounting surface.
1. Position the control and mark the mounting holes.
2. Start screws (not provided) for the keyhole type mount-
ing holes in the upper corner(s). Tighten the screws down to
a screw to be installed in the lower left hand corner after the
control is hung and leveled.
3. Hang the control on the screw(s), position the case, and
start the bottom screws.
4. Tighten all screws.