Operator`s manual

64
SECTION 11
ACCESSORY INFORMATION
11.12 WINDSHIELD (Part Nos. 648-79 & 648-80)
The windshield features an anodized aluminum frame with
rubber mounted 24" high x 48" wide laminated safety glass.
It mounts to the top of the dash area of any Argo model, folds
down and secures in place over the hood and is required for
the convertible top.
When the windshield is raised in the upright position, it
must be supported by the two side support arms. Attach
both support arms to the windshield frame brackets
using the quick pins supplied. Do not attempt to fasten
the front of a convertible top to the windshield until the
support arms are in place.
DO NOT transport the Argo at highway speeds with
the windshield upright. For transportation at highway
speeds, it is recommended that the vehicle be reversed
on the truck or trailer so that the front of the Argo faces
to the rear. The windshield should be folded down and
secured in place using a rope or a tie down strap.
Operating the Argo for extended periods in high ambient
temperatures with the windshield in the folded down po-
sition may restrict hot air ow from the engine compart-
ment which could lead to engine overheating and heat
build-up in the windshield frame and glass. Use caution
when operating the vehicle with the windshield folded
down to avoid overheating in warm temperatures.
The following decal should be attached to the inside of the
windshield:
If this decal is not attached to the windshield, contact your
Argo retailer for a free-of-charge replacement. The part
number is 126-84.
11.13 CONVERTIBLE TOP (Part Nos. 649-51, 849-40,
849-45 & 849-51)
The convertible top provides protection from the elements for
the occupants and offers the option of rolling up or removing
the side doors, rear door and rear side panels while leaving
the overhead portion in place.
Never fold the clear plastic windows; always roll them
up to store them in place on the top assembly or remove
them.
To fold the convertible top for storage, unzip the side and
rear doors and the side panels, lay them aside and unsnap the
domes along the front of the roof panel from the windshield
frame. Fold the aluminum top frames together and roll the
overhead panel around the frames loosely. Then, roll the
window panels around the top material so the boot will cover
the complete assembly for protection.
The convertible top assembly is not designed to withstand
the turbulence created while transporting the vehicle
with the top assembled in the ‘up’ position. Fold the top
down and secure it properly to the vehicle bodyor remove
it from the vehicle for high speed transportation.
Hearing protection is strongly advised when operating
the vehicle equipped with any convertible top assem-
bly.
The following decal should be attached to the inside of the
windshield:
If this decal is not attached to the windshield, contact your
Argo retailer for a free-of-charge replacement. The part
number is 126-84.