Operator`s manual
59
SECTION 11
ACCESSORY INFORMATION
8. Deate the front and rear (or all tires) for easier instal-
lation of the nal track pin.
9. Join the two ends of the track and secure them in place
with C-Clamps as shown in Figure 11-10, so that the
holes of the hinge lacing line up.
Figure 11-10. Securing with C-clamps.
10. Insert the 825-56 Track Pin through one of the 108-23
washers and then through the hinge lacing. Be sure to
install the pin from the outside edge of the track so
the end with the cotter pin hole ends up nearest the
vehicle lower body.
11. Secure the Track Pin in the hinge with a 108-23 washer
and 100-100 cotter pin at end closest to the vehicle
body.
12. Re-inate the tires as shown in the chart. With the tires
installed and inated as shown in the chart, there should
be 2 to 3 inches between the bottom of the second (or
third) tire and the inside surface of the track when the
vehicle is elevated. Figure 11-11 & 11-12 for Avenger
and Figure 11-13 & 11-14 for Frontier. This may require
the installation of a track extension or additional hinge
kit. For Avengers with typical 79-80" tires, the total track
length should be 235" (including hinges and track exten-
sions.) For Frontiers with typical 76-77" tires, the total
track length should be 189" pin to pin. The extension
can be easily removed if the wheels slip within the track
during winter use. NOTE: Putting too much tension
in the track will severely stress the axles, bearings and
frame.
Figure 11-11. Measuring the gap of the mid tires - Avenger.
Figure 11-12. Measuring the gap of the mid tires - Avenger.
Figure 11-13. Measuring the gap of the mid tire - Frontier.