Operator`s manual
47
SECTION 8
TROUBLE SHOOTING
MALFUNCTION PROBABLE CAUSE CORRECTIVE ACTION
(SYMPTOM)
Electric starter inoperative 1. Loose electrical connections 1. Clean and re-tighten electrical
connections
2. Battery charge low or dead 2. Recharge battery or replace as
necessary
3. Faulty starter motor 3. Return the vehicle to an Argo
dealer for servicing
Engine turns over but will not 1. Engine is cold and choke is not 1. Pull out the choke and try to start
start pulled out again
2. Fuel tank is empty 2. Rell tank
3. Blocked fuel or air lter 3. Remove obstruction or replace
lter as necessary
4. Carburetor adjustment too lean 4. Adjust as detailed in the engine
manufacturer’s manual
5. Spark plugs defective or fouled 5. Clean and re-gap or replace
6. Ignition system inoperative 6. Have unit serviced by a properly
trained and equipped mechanic
7. Insufcient compression 7. Take the vehicle to a factory
authorized engine repair outlet
Engine will not run 1. Refer to engine manual
Vehicle will not move or turn 1. Transmission in neutral or not 1. Place gear shift properly in gear
properly engaged in gear
2. Drive belt worn (see Section 7.2.1) 2. Replace belt if worn excessively
3. Clutch not engaging 3. Return the vehicle to an Argo
dealer for servicing
4. Transmission failure 4. Same as 3. above
5. Brakes not functioning 5. Adjust caliper or replace brake
pads
6. Idler chain broken 6. Repair or replace
7. Idler sprocket weld broken 7. Have vehicle serviced by an Argo
dealer
Vehicle pulls to right 1. Right tire pressure too low 1. Inate all tires to the correct
pressure
2. Left tire pressure too high 2. Same as above
3. Right brake engaged 3. Make sure the handlebar is held
parallel to the dash. Adjust brake
assembly if required.
4. Right side drive chain broken 4. Repair or replace
Vehicle pulls to left 1. See “Vehicle pulls to right” -
substitute right with left
HDi and HD - Vehicle does not shift
1. Hi/Low shift cable adjustment 1. Take the vehicle to an Argo dealer
into Hi from Low or Low from Hi
for servicing
Handbrake failure - Avenger 1. Worn brake pads, brake cable 1. Change pads or adjust brake cable
and Frontier adjustment
- HDi and HD 2. Worn brake pads 2. Change pads
3. Leaking caliper or brake lines or air in 3. Take the vehicle to an Argo dealer
system for servicing