Service manual
Argo Service Manual Wheels, Axles & Chains
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-9
3. Replace the outside plate and spring clip. The open end of the clip must face rear-
ward when it is on top of the chain. Photo WA-10
WA-10
WA-11
4. Remove the vice-grips and connect the chain tensioner spring between the upper and
lower chain tensioner arm. Photo WA-11
5. Reinstall firewall and floorpans.
Earlier vehicles used an open ended spring clip. New models have a closed ended spring
clip. Face this rearward as well.
On 8x8 models manufactured from serial numbers CB16049 & RB16104, or
6x6 models from serial numbers BF9212, C12747, SN10191 & S10178:
1. Position the drive chain over the slider block and around the drive sprockets.
2. Pull the ends of the chain together and insert the connecting link as shown in DIA-
GRAM WA-8 & 9. When connecting the RC50-2 chain, insert the inside plates
before tapping the connecting link through the second set of links. The rear single
RC60 chains have no inside plates.
The chain tensioner system must be secured in it’s lowest position to the frame as
illustrated in DIAGRAM WA-5 on page WA-6.
3. Replace the outside plate and spring clip. The open end of the clip must face rear-
ward when it is on top of the chain. Newer style clips have a closed end.
Drive Chain Installation