Service manual

Wheels, Axles & Chains Argo Service Manual

Ontario Drive & Gear Limited www.odg.com

PH.(519)- 662-2840 FAX (519)- 662-2421

6. Install a cork gasket at the front aluminum axle extension followed by a steel inner

flange and second cork gasket. Photo WA-12

WA-12 WA-13

7. Apply some anti-seize compound to the spline area of the axle shaft. Photo WA-13

8. Slip the axle assembly into the front bearing extension. Photo WA-14 On the inside

of the vehicle, prepare to install the front sprocket as the axle is pushed through to

the inner bearing.

IMPORTANT

The front axle sprocket is a "floater" and requires no set screws. Orient the

sprocket with the larger shoulder facing towards the inside of the vehicle. Photo WA-

WA-15WA-14

9. Align the mounting holes of the greasable flange with the studs of the aluminum

bearing extension and place into position up tight against the cork gasket. Photo

WA-16

10. Install flat washers to the studs. Photo WA-17

WA-53A