Service manual

Wheels, Axles & Chains Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
9. Remove set screws at the inner bearing collar.
10. Loosen off the inner bearing flange hardware.
11. Remove the (4) nuts that secure the outer bearing greaseable flange. Photo WA-4
WA-4 WA-5
12. Using a soft faced hammer, tap the wheel hub from behind to remove the axle from
the vehicle. Photo WA-5 & 6
WA-6 WA-7
The outer bearing, greasable flange,and axle will be removed as an assembly. Retrieve the
drive sprocket from inside the vehicle once the axle has been completely removed from the
vehicle.
13. Remove the set screws from the collar of the outer bearing.
14. Using an arbor press, press the bearing and greasable flange from the axle shaft.
Photo WA-7
15. Clean all components in a varsol bath and inspect.
16. Perform the servicing procedure, Removing the Axle Seals, in the Wheels, Axles &
Chain section of the 673-04 Argo Service Guide.
WA-51A