Service manual

Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
Argo Service Manual Wheels, Axles & Chains
4. Install the 100-111 bulk head fittings to the left and right side of the frame and con-
nect the tube to the swivel grease fittings of the two inner bearings. Photo 15 I
There are 2 different lengths of grease tubing for the left and right hand side idler shaft
assembly. See your Avenger parts manual for correct lengths.
15 H
5. Install the idler shafts to the vehicle, inserting the shaft first into the inner bearing
and then attaching at the outer bearing. See orientation of sprocket collars below.
Photo 15J & 15 K
15 J
15 I
15 K
WA-34A
Assembling Idler Shafts To The Vehicle (Avenger Models From Serial # 25622)
810-59 Idler Shafts used on later Avenger models have a retaining ring installed to each
side of the idler shaft drive sprocket. These retaining rings help limit allowable movement
of the idler sprocket under application. As these 810-59 Idler Shafts are also common to
Conquest, Response and Bigfoot, there are (4) machined retaining ring grooves on each
shaft to accommodate each of these models. However, placement of the retaining rings is
dependant not only on model, but also whether it is a right hand side or left hand side idler
shaft. See Diagrams A and B for correct retaining ring locations (circled) on Avenger
models.