Service manual

Wheels, Axles & Chains Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-54
2. Fasten the extension to the lower body.
Torque ot specifications. Photo WA-135
3. Perform the servicing procedure, In-
stalling an Axle (With Bearing Exten-
sion).
Removing the Inner Bearing
1. Perform the servicing procedure, Re-
moving an Axle, steps 1through 8. The
axle needs to be pulled from the inner
bearing to be serviced. The axle assem-
bly should be pulled completely at this
point so that the old gasket at the outer
bearing flange may be replaced with a
new one.
2. Remove the inner bearing flange hard-
ware securing the bearing to the frame
and remove the assembly to a clean
work surface. Photo WA-136
Installing the Inner Bearing
Assembling the Inner Bearing and Flange
Assembly
1. Place the bearing into the greasable
flange with the set screw collar facing
down. At the same time align the small
hole in the bearing with the grease fit-
ting in the flange. Photo WA-137
IMPORTANT
6x6 Vanguards manufactured prior to S/N S7447, differ in axle and bearing setup.
These vehicles require the inner bearing to be assembled to the greasable flange with
the collar facing up, but still aligning the small hole in the bearing with the grease
fitting in the flange.
WA-135
WA-136
WA-137