Service manual

Wheels, Axles & Chains Argo Service Manual
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-48
10. Place a cork gasket on to the outer flange. Photo WA-117
11. Place the inner flange on top of the cork gasket. Photo WA-118
12. Place a second gasket to the top of the inner flange. Photo WA-119
If you have a single seal greasable flange, the fitting is at 12 o'clock.
14. Locate the drive sprocket and slip it on
to the axle with the set screw hole fac-
ing to the inside. Photo WA-121 Be
sure that the set screw hole of the
sprocket, is aligned with the spline on
the axle with the machined countersinks.
15. Align the end of the axle with the inner
bearing. Push the axle the remaining
way and install the flange hardware. Photo WA-122
13. Assemble the 4 carriage bolts to the outer flange and install the axle assembly into
the lower body and frame. Orient the greasable fittings so that the outer grease
fitting is at the 9 o'clock position, and the inner one is at12 o'clock. Photo WA-120
WA-117 WA-118
WA-119 WA-120
WA-121