Service manual

Argo Service Manual Wheels, Axles & Chains
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-41
10. Place the V block and square on to the idler shaft, pushing the square up against the
inner drive sprocket. Photo WA-94
WA-94 WA-95
11. Tap the idler shaft using a soft face mallet until the square contacts the upper
sprocket. Photo WA-95
12. Once aligned, the idler shaft must be drilled at the two bearing set screw locations
of the inner bearing. Using a 3/16" drill bit, drill the idler shaft axle using the set
screw hole as a guide. The idler shaft need only be drilled enough to provide a
good seat for the set screw when it is installed.
Use extreme caution when drilling to prevent any damage to the inner bearing set
screw threads. Be sure drilling is done perpendicular to the shaft and does not come
into contact with the threads of the set screw holes.
13. Apply Red 271 LOCTITE to the set screw threads and holes of the inner & outer
bearings and tighten securely. Torque to specifications.
18. Reinstall the brake caliper. The hydraulic brake caliper (Vanguard2), should still be
connected to the brake line. See NOTE following page.
16. Perform the servicing procedure, Installing the Brake Disc in section BR.
14. Perform the servicing procedure, Drive Chain Installation. Install the front drive
chain, connecting the front wheel to the idler axle, as well as the drive chain con-
necting the middle (6 wheel)or mid/front (8 wheel) to the idler axle.
17. Perform the servicing procedure, Idler Chain Installation.
15. Perform the servicing procedure, Idler Shaft Bearing Lubrication.