Service manual

Argo Service Manual Wheels, Axles & Chains
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-39
Installing the Idler Shaft (Vanguard & Vanguard2 Models)
1. Place the inner flange to the studs located beneath the power pack frame.
Photo WA-88
2. Place a gasket to the previously installed flange. Photo WA-89
3. Assemble the greasable flange to the idler axle assembly.(Larger diameter sprocket
end). WA-90
4. Slip the inner bearing to the same end as the greasable flange, with the collar facing
in. Photo WA-91
WA-90 WA-91
WA-88 WA-89
IMPORTANT
6x6 Vanguard and Vanguard2 idler axles, unlike those used on Conquest, Response,
Bigfoot or Conquest 6x6, have a distinct left and right hand side. When replacing an
idler axle, keep this in mind and order accordingly.
5. Install inner flange, bearing, and outer flange to the opposite end of the idler shaft.
Photo WA-92 See note following page.
11. Perform the servicing procedure, Installing the Firewall in section VB.