Service manual

Argo Service Manual Wheels, Axles & Chains
Ontario Drive & Gear Limited www.odg.com
PH.(519)- 662-2840 FAX (519)- 662-2421
WA-13
1. Remove the floor pans and the appropri-
ate drive chain.
2. Turn the tensioner cam assembly in the
direction which winds up the torsion
spring and push the assembly down as
close as possible to the cam follower
block across the bottom of the frame
channels. Clamp it in this position with
a Vice-Grip 10CR or similar plier as il-
lustrated in DIAGRAM WA-16
3. With pliers, pry the slider block off the
cam assembly as illustrated in
DIAGRAM WA-16
4. Place a new slider block over the shaft
of the cam assembly.
5. Using a piece of wood (or similar mate-
rial) pressed against the top of the slider
block, carefully hammer the piece of
wood so the slider block snaps onto the
cam assembly shaft as shown in
DIAGRAM WA-17
6. Reinstall the drive chain and remove the locking pliers securing the cam assembly in
its lowest position.
7. Pull up on the cam assembly to allow it to take up as much chain slack as possible.
8. Replace the floor pans.
Replacing the Slider Block:
WA-16
WA-17
Disassembling the Chain Tensioner System
On 8x8 models manufactured prior to serial numbers CB16049 & RB16104, or
6x6 models prior to serial numbers SN10191 & S10178:
1. Remove the front or rear floorpan.