Operator`s manual

52
SECTION 11
ACCESSORY INFORMATION
11.23.1 Dump Box Operating Guidelines
1. For quick removal of the box disconnect the actuator or
springs then disconnect the rear hinge pins 104-32.
2. The rear side seats can still be used if you remove the
dump box and undercarriage.
3. A rear bench seat kit 849-60 can be used when the dump
box is removed. The undercarriage frame support plates
are in the same location as the rear bench seat frame sup-
port plates. So the seat can quickly be attached without
any additional mounting.
11.24 ROLL BAR KIT (Part No. 648-15)
The roll bar is designed for use on all Argo 6 x 6 models. The
roll bar provides some roll over protection and lap belts for the
driver and front seat passenger.
When the Roll Bar Kit is installed, ALWAYS wear seat
belts when operating the vehicle on land. REMOVE
seat belts when entering water.
Maximum total vehicle weight must not exceed 1465
lbs. or 665 kg. which means 2 people and 100 lbs. or 46
kg. of cargo in the vehicle.
Never attach anything to the Roll Bar other than On-
tario Drive & Gear 648-15 Roll Bar specific accesso-
ries.
The Roll Bar reduces vehicle stability. Always use com-
mon sense when traveling over rough terrain.
The Roll Bar is designed to reduce the chance of injury.
DO NOT rely on it to protect the vehicle occupants from
irresponsible driving.
The Roll Bar could come in contact with tree branches.
Falling branches or vehicle upset could occur. Use ex-
treme caution when traveling on narrow tree lined
trails.
DO NOT use the Roll Bar as an attachment point for
towing or winching.
Check the torque of the Roll Bar nuts and bolts annu-
ally and replace any parts that are damaged. When the
Roll Bar is installed, never carry more than two people
in the Argo.
Replace worn or damaged seat belt straps and buckles.
Failure to comply with the above could result in per-
sonal injury or death.
11.25 12V Accessory Outlet Kit (Part No. 633-25)
The 12V Accessory Outlet Kit contains a 12V outlet, wire har-
ness complete with in-line fuse holder & fuse, and the neces-
sary hardware to mount the outlet in the upper body of any
Argo model. When mounting the outlet, be sure to select an
area within reach for the wire harness. The wire harness gets
connected directly to the battery terminals so any mounting
location chosen, must allow the harness to reach both the
outlet and the battery. When mounting, be sure that the wire
harness is securely clipped into place and not left dangling
near moving parts within the engine compartment.
Because the outlet is wired directly to the battery, it is
constantly "live," even without the key turned on. Ex-
cessive use will run down the battery.
This outlet is NOT designed to support nor should it be
used as a cigarette lighter socket.