User`s manual

3. The frequency editor window will open up and have defaults loaded in the slots.
4. There are eight total frequency slots provided, but only two can be used at any given
time. Normally, this would be slot 1 and slot 2. Use the selection dots (also known
as “radio buttons”) to assign a frequency slot to the primary and secondary channels.
Primary Channel is the default frequency used on power up and is controlled by the
beaconing timing/scheme selected on the primary configuration window.
Secondary Channel is used only at the specified beacon rate typed into the “Use
secondary every” box.
The example showed above will beacon on the primary frequency based on your
beacon timing/scheme selected on the main page. The secondary frequency will be
beaconed every 5 beacons on the main frequency. This gives you a 5:1 beacon ratio.
Important! If SINGLE frequency operation is desired, set the primary AND secondary
selection dots to slot 1. Also, make sure than the “beacon secondary every” box has a
zero (0) typed into it. This will disable any dual-frequency options.