User`s manual

OpenTracker USB User’s Manual 29
RETRYTIME <0-255> (seconds)
Time between message retry attempts - interval increases by this value
with each transmission.
REQALL on|off
Require all configuration switch parameters to be met before switching
profiles.
RESET
Perform software reset. Saved settings are unaffected.
RING on|off
Sends a bell character whenever an incoming message arrives.
SCRIPT on|off
Enables the script engine.
SECRET <pass phrase>
Sets the pass phrase for the one-time password authentication system.
SEND <callsign> <message> (local only)
Sends a text message to the designated recipient.
SHAREDPTT on|off
Controls PTT line behavior for mic encoder mode. If enabled, PTT output
is not asserted until the PTT input is released.
SLOT <0-65535>
Time slot for transmission (if TIMESLOT is on). Slot position is counted in
seconds from the start of the hour.
SMARTBCON <low speed> <high speed> <low rate> <angle> <time>
Configures SmartBeaconing. The SmartBeaconing algorithm allows the
tracker to operate more efficiently by changing how often it transmits
depending on its speed and turn rate.
When stopped or moving at a speed below the low speed setting, the
tracker will transmit at a fixed rate determined by the lower rate setting.
Above the specified high-speed threshold, the higher rate setting is used.