User`s manual

Tracker3 User’s Manual 41
REQALL on|off
Require all configuration switch parameters to be met before switching
profiles.
RESET
Perform software reset. Saved settings are unaffected.
RING on|off
Sends a bell character whenever an incoming message arrives.
SCRIPT on|off
Enables the script engine.
SECRET <pass phrase>
Sets the pass phrase for the one-time password authentication system.
SEND <callsign> <message> (local only)
Sends a text message to the designated recipient.
Return value: Number of retries remaining
SHAREDPTT on|off
Controls PTT line behavior for mic encoder mode. If enabled, PTT output
is not asserted until the PTT input is released.
SLOT <0-65535>
Time slot for transmission (if TIMESLOT is on). Slot position is counted in
seconds from the start of the hour.
SMARTBCON <low speed> <high speed> <low rate> <angle> <time>
Configures SmartBeaconing. The SmartBeaconing algorithm allows the
tracker to operate more efficiently by changing how often it transmits
depending on its speed and turn rate.
When stopped or moving at a speed below the low speed setting, the
tracker will transmit at a fixed rate determined by the lower rate setting.
Above the specified high-speed threshold, the higher rate setting is used.
Between these two extremes, the interval varies between the low rate and
high rate (specified separately with the INTERVAL command) depending
on the speed.