User`s manual

Tracker3 User’s Manual 39
PASSALL on|off
Normally the Tracker3 ignores all received packets that fail a frame check
sequence test. PASSALL disables the FCS test. This option should only be
used for troubleshooting as it will result in output of corrupted packets.
PASSLIST [n] (local only)
Generates a list of the next n one-time passwords to be used, based on the
pass phrase entered with the SECRET command. Default is 144.
PATCH <hex string>
The patch command allows direct modification of the contents of the
Tracker3’s flash memory. This command should only be used as directed
by the manufacturer. Improper use of this command may render the
Tracker3 inoperable.
PATH <call1,call2,…>
Comma-separated digipeater path list, containing up to three digipeater
addresses.
POSITION <hhmm.mmx hhhmm.mmx> | GPS
Sets fixed position or enable GPS. Position must be entered in degrees
and decimal minutes, including leading zeros. Setting position to 'GPS'
reverts to GPS tracking mode.
Example: POSITION 4851.49N 00217.66E
Return value: 0 = Using GPS, 1 = Fixed Position, 2 = Position Unknown
POWER on|off|<0-255> (seconds)
ON or OFF will manually set the state of the power output. Specifying a
value in seconds will enable automatic power control mode, where the
power output is turned on for the specified number of seconds prior to
transmission, and turned off immediately after transmission.
Return value: 0 = Off, 1 = On, 2 = Timed
PREEMPT <n> on|off
Enables digipeater preemption for alias <n> (1-8). If preemption is
enabled, packets will be digipeated on this alias even if it isn't the next
address in the packet’s digipeater list.