User`s manual

FCC Part 15 Notice
This device complies with Part 15 of the FCC Rules Operation is subject
to the following two conditions: this device may not cause harmful
interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B Digital Device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communication. However, there is no
grantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by tuning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
CE Declaration
This device complies with the essential protection requirements of the
European Parliament and of the Council Directive 2004/108/EC on the
approximation of the laws of the Member States relating to
electromagnetic compatibility. Assessment of compliance of the
product with the requirements relating to electromagnetic compatibility
was based on the following standards:
EN 55022 : 2006
EN 61000 - 3 - 2 : 2006
EN 61000 - 3 - 3 : 1995+A1 : 2001+A2 : 2005
EN 55024 : 1998 + A1 : 2001+ A2 : 2003
EN 61000-4-2 /-3 /-4 /-5 /-6 /-11