Installation Guide

Pro Tip: If you make a mistake, simply lift bricks & place where you want them.
Pro Tip: It takes about 17 bricks to make the smallest circle of 42” diameter.
BRICKS CONNECTOR END CAP SOLAR BRICK
Check that you have all items:
If something is missing, call us directly at 619-449-5050
Instructions - Read before starting your project
RG825
Bricks=35
Connectors=35
End caps=2
RG820S
Bricks=24
Solar Bricks=4
Connectors=28
End caps=2
RG840S
Bricks=50
Solar Bricks=6
Connectors=56
End caps=2
Before you begin...
Ensure your ground is soft enough to
press in spikes. If not, wet ground thor-
oughly 24 hours prior to beginning.
It may be helpful to draw a line on ground
to follow when installing bricks.
Couple feet short? Want extra solar bricks?
Additional items may be purchased from where you
originally bought the kit or at argeecorp.com.
Search RG872 for 2-solar cubes, RG873S for 2-solar
lighted bricks & RG874 for a 4-pack of bricks.
1
Take 10-12 Let’s Edge It!
®
bricks and lay them on
the ground with a gray connector in-between each
one. Turn all pieces over & begin snapping bricks
and connectors together.
Pro Tip: If your kit includes solar lighted bricks, intersperse them throughout the bricks where desired.
2
Turn bricks over so spikes are facing down and
begin placing on ground in the area where you
want to install them.
3
Begin pressing bricks into the ground being careful
with the spikes. Leave the last 3 bricks out and
add gray connectors and bricks to the end of the
line until all bricks are connected and pressed in.
4
Curve or go straight.
Finishing up...
• Place an end cap where an open end is seen. Install from inside the brick, snap into place.
• If final brick is too long, shorten using a hand saw or table saw to proper length.
• To make a 90
O
angle, see back for detailed instructions.
Pro Tip: DO NOT force bricks and connectors
together, they should snap together easily.
Solar cubes
made in China
If you encounter any problems with Let’s Edge It!
®
DO NOT return to where purchased.
Contact Argee™ at [phone] or email us: [e-mail]