Instructions Circuit Diagram

- 48 -
10. SOFTWARE INSTALLATION AND
INITIAL STEPS
Insert the YETI CD. When all is OK it will start automatically, otherwise open
itwithwindowsexplorer.Afterthelanguageselectionyouwillndallthe
programs you need for the YETI under the software menu. Before you can
workwiththemyouhavetoinstalltheprogramonyourharddriverst.To
install programs on your hard drive, you need administrator rights. When you
are not logged in as administrator, log out and log on again as administrator.
During the software installation the following will take place:
1. Flash-Tool, a program to transmit your own program to YETI, will be
installed.
2. A program editor (Programmers Notepad 2, PN2) and a Compiler
(WinAVR) will be installed.
3. An example program(s) will be copied from CDRom to your hard disk.
4. Inprogrameditor(PN2),amenuinputforMakeandCleanles,will
be created.
10.1 Windows
10.1.1 Flash-Tool
CopytheashprograminafolderonyourharddriveforexampleC:\
programs\ash.
ItisalsopossibletoruntheashprogramdirectlyfromtheCD.
Inallcases,itiswisetomakealinkfortheashprogramonyourdesktop.
10.1.2 Installation of the program editor and compiler
For the installation of the compiler you must be the administrator of your
computer (during the installation the registry will be changed). When you
are not registered as the administrator, restart the computer and start up as
administrator!
Click on the install symbol to install.
COMPILER WinAVR (20060421)
WINDOWS is the trade mark of Microsoft Corporation.