Instructions Circuit Diagram

- 41 -

8. CHARGING THE YETI BATTERIES

The YETI power voltage is 4.8 Volt supplied by 4 NiCd (1,2V) batteries.

IMPORTANT:

The batteries are not protected by a fuse or series resistor!

Be sure that you are using a good quality battery charger. Best is a

microprocessor controlled type!

Or use a stabilized power adaptor with a very small loading current,

for example 5 Volt / 300 mA.

DC connector

Middle = +

Switch

Charching YETI batteries:

1. Connect the charger to the DC connector.

2. Put the switch in the off position!