User's Manual

Receiver
ID reset button
1. Insert the batteries
A. Open the battery cover on the back of the presenter
B. Fit in the batteries according to the diagram indicated in the
battery compartment.
C. Close the battery cover.
2. Connect the presenter and the receiver
A. Pull the receiver from the bottom of presenter.
B. Plug receiver into the USB port of your PC
3. Establish communication between the presenter
and the receiver
Remote trackball :
The trackball can be used as a pointing device to move the
cursor
Right / Left button:
Using left and right buttons as a mouse's right and left buttons.
Timer setting for presenter:
This is to allow you to set the presentation duration from 10
minutes, 20 minutes, up to 60 minutes. You can adjust it according
to your demand. Once the time is set, the presenter will alarm you
by vibration 5 minutes before ending of your presentation, and
alarm again while ending.
Re-set timer: Re-press Timer Setting button again to re-set
An incorrect battery placement may
cause batteries over heat.
+
-
2 AAA batteries
PC
USB port
Battery compartment
Battery cover
Press ID reset buttonRed Led indicator
blinks slowly
Press ID reset button Red Led indicator
blinks faster
1
2 3 4 5
ID links OK!
3 4
4. Operation
A. Auto-link mode:
The presenter has auto-link function itself.
B. Manual mode:
1. Press the ID reset button on the front of the receiver(step 1),
and make sure the red LED will blink slowly.(step 2)
2. Press the ID reset button in the right side of the presenter .(step 3)
3. The Receiver's red LED indicator will blink at a faster rate until
an identical ID is set up.(step 4)
4. The ID indicator of the receiver will blink any time when the
presenter is working.