User's Manual

Press ID reset button
2. Connect the receiver
a. Turn off your PC.
b. Connect the receiver cable to USB port on PC
c. Turn on your PC
PC
Red Led indicator
blinks slowly
USB port
Press ID reset button
Red Led indicator
blinks faster
PC
USB port
4. Recharge the batteries
When the mouse Low Power indicator signals, please recharge the batteries by putting the
mouse in the cradle and connect the USB cable to the USB port of your PC. (Make sure
that you are using rechargeable batteries inside). It takes about 5-6 hours to completely
recharge the batteries.
1
2
3 4
ID links OK!
3. Establish communication between the mouse and receiver
A. Auto-link mode:
The mouse has auto-link function itself.
B. Manual mode:
a. Please reset the ID when first time use if necessary.(step 1)
b. Press the ID reset button on the receiver cradle, and note the red LED will blink slowly.
(step 2)
c. Press the ID reset button on the bottom of the mouse to set a new ID. (step 3) The red
LED indicator will blink at a faster rate when an identical ID is located.(step 4)
d. Press any button of the mouse to confirm the ID matching. The red LED indicator on the
receiver will blink any time the mouse sends it a signal.
The red LED on the top case of the mouse is a low batteries power indicator. It
indicates that batteries inside the mouse need to be recharged.
If the batteries are used up, you may need to take out the batteries, reinstall again,
and reset the ID to recharge it.
The mouse surface may be warm during charging process. It is a normal phenomenon.
Note
[Mouse] Green LED Light ON - Charge completed
[Mouse] Red LED flashing - Low Battery
[Cradle] Orange LED Light ON - Charging
[Cradle] Green LED Light ON - Charge completed
★ LED Display Status
After Recharging
1. Removing the mouse from the charging cradle when charging is completed.
2. Make sure the communication between the mouse and the receiver is still available after
completing recharging batteries. If not, please refer to the channel setting instruction (refer
to No. 3) in the manual to reset the communication.
5. Operation
4D Scrolling (optional):
a. Vertical Scrolling
Roll wheel up to scroll up; roll wheel down to scroll down.
b. Horizontal (tilt) scrolling (optional)
Push wheel left and hold the scroll left; press wheel rightand hold to scroll
right. Release wheel to stop scrolling function.
a.
b.
(optional)
The tilt scrolling function is only effective under successful installation of the
original mouse driver. The driver is an optional item included in the package
or it can be downloaded from the website of the local brand vendor.
Note
B. Driver Installation
The mouse features plug & play. It is not necessary to install the driver to operate the mouse.
The driver is an optional item included. However if the model purchased is with 4D tilt
function, you may require the mouse software driver to make the tilt scrolling function
effective.