User's Manual

ID reset button
Receiver
ID reset button /
Led
1. Insert the batteries
a. Remove the battery compartment cover on the back by pressing
the battery cover button of the mouse.
b. Fit in the batteries according to the diagram indicated in the
battery cabinet.
c. Close the battery compartment cover.
2. Connect the receiver
a. Turn off your PC.
b. Connect the receiver cable to USB port on PC
c. Turn on your PC
It is a MUST to fully recharge the rechargeable batteries contained in this package at
the first-time use.
The unit offers a strong power saving management. Once the mouse accesses the
sleeping mode, " to click any button of the mouse" is compulsory to wake it up.
Power on/of f:
1. To save the power, please turn off the mouse by pressing and holding the on/off
switch on the bottom of the mouse with 3-5 seconds.
2. To turn on the power, just repeat the same step as above again.
4. Recharge the batteries
To charge the battery, plug the receiver into the front side of the
mouse, according to the diagram instruction. Then, pull out the
retractable cable and plug it to an USB port, the mouse become a
wired optical mouse. When the receiver is plug into the socket, the
battery is charging when you're using the mouse.
(ID reset button)
Red Led indicator
blinks faster
Green LED Light ON - Recharging
Green LED Light OFF - Recharging completed
Red LED flashing - Low Power
+ -
Batteries
Battery cover
ɘ!Mouse LED Display status
PC
Wheel button
Battery cover
ID reset button/
Power on/off
switch
Receiver
Mouse
Receiver
Low power Led /
Charging Led
Introduction
Congratulations on your purchase of the World first 2-in-1 Mini
wired/wireless rechargeable optical mouse, which includes optical
technology, the radio frequency technology. The mouse can be used
as a wirelsss mouse, and also as a wired mouse.
The world first patented wired + wireless mouse
27 MHz RF
Plug the receiver to the front of the mouse to be a wired mouse
Battery's recharged when the mouse is used as a wired mouse
Plug and Play! No need to set the channel ID
2*AAA charging batteries included
800 dpi
Press
Press
Battery cover
button
Battery cover
button
The red LED on the top cover of the mouse is a low batteries power indicator. It
indicates that batteries inside the mouse need to be recharged.
If the batteries are used up, you may need to take out the batteries, reinstall again,
and reset the ID to recharge it.
The mouse surface may be warm during charging process. It is a normal phenomenon.
Note
Installing Instruction
A wrong battery placement
may cause batteries overheat.
(ID reset button)
Red Led indicator
blinks slowly
3. Establish communication between the mouse
and receiver
A. Auto-link mode:
The mouse has auto-link function itself.
B. Manual mode:
a. Please reset the ID when first time use if necessary.
b. Press the ID reset button on the topside of the receiver, and note
the red LED will blink slowly.(pic.1)
c. Press the ID change button on the bottom of the mouse to set a
new ID. (pic.2) The red LED indicator will blink at a faster rate
when an identical ID is located.(pic.3)
d. Press any button of the mouse to confirm the ID matching The
red LED indicator on the receiver will blink any time the mouse
sends it a signal.
USB port
1
2
3 4
ID links OK!
After Recharging
1. Disconnect the recharging cable from the mouse when charging
is completed.
2. Make sure the communication between the mouse and the
receiver is still available after completing recharging batteries. If
not, please refer to the channel setting instruction in the manual
to reset the communication.