AZSQ3300 Ares XView Manual

19
Problem Diagnosis Cure
The quadcopter lights continue
to ash when the transmitter is
turned on and the quad will not
operate.
1. The quad has failed to pair
with the transmitter.
2. The quad has insufcient
battery power.
1. See the section headed
‘Preparation For Flight’ and
follow steps 2 - 5.
2. Fully charge the LiPo
battery.
The propellers turn but the
quadcopter will not take off.
1. The quad has insufcient
battery power.
2. One or more propeller
blades are damaged or
deformed.
3. Propellers incorrectly
located
1. Fully charge the LiPo
battery.
2. Replace the damaged /
deformed propellers.
3. Check and reposition as
shown on page 8.
The quadcopter shakes in ight. 1. One or more propeller
blades are damaged or
deformed.
1. Replace the damaged /
deformed propellers.
The quadcopter is unstable in
ight and difcult to trim.
1. One or more propeller
blades are damaged or
deformed.
2. One or more of the motors
is faulty.
1. Replace the damaged /
deformed propellers.
2. Replace the faulty motor(s).
The quadcopter is
uncontrollable following a
collision.
1. The gyro may have lost its
settings.
1. Follow the Gyro Calibration
procedure detailed on page
18.
The propellers turn but the
quadcopter will not take-off.
1. The quad has insufcient
battery power..
2. One or more propeller
blades are damaged or
deformed.
3. The propellers are
incorrectly located.
1. Fully charge the LiPo
battery.
2. Replace the damaged /
deformed propellers.
3. Refer to the section entitled
Propeller Identication on
page 18.
Troubleshooting Guide