AZSQ3300 Ares XView Manual
15
elevator stick forward the quad will y forward, if you pull the stick back it
will y back. Left aileron stick will move it to the left and right aileron stick
will move it to the right. However, if you now yaw the quadcopter 45° to the
left and repeat the process, forward elevator stick will still make it y away
from you, whist pulling back on the elevator stick will bring it back towards
you. Left aileron will continue to move it to the left and right aileron will
continue to move it to the right.
5. Select IOM (press the right-hand stick) once more to switch the function off
and return to normal ight. With IOM switched off the LED lights will stop
ashing and light solid.
If your XView was facing North when IOM was activated this compass bearing
will be stored and reactivated (for the duration of the ight) whenever the IOM
button is pressed. To alter the heading the IOM function must be recalibrated
as below:
1. Prepare your XView for ight and arm the motors.
2. Position the quadcopter directly in front of you with the camera facing
forward.
3. Pull both transmitter sticks as far back as they will go then place the left-
hand stick in the bottom right-hand corner of the gimbal and the right-hand
transmitter stick in the bottom left-hand corner of the gimbal.
4. After a short pause the XView’s LED lights will ash to conrm that re-
calibration is in process. Hold the sticks in position until the lights stop
ashing. Successful recalibration will now have taken place.
IOM (Press)