AZSQ3300 Ares XView Manual

DOWN

LEFT RIGHT

Note: With a charged battery the XView will y for approx 4 minutes. At the end

of your ight low battery power will be indicated when the XView’s LED lights

begin to ash. When this happens you should land within 30 seconds and

recharge the LiPo.

Trimming

In order to maintain a suitably stable hover you may nd it necessary to trim the

model to correct any ight path deviation. This is done using the transmitter’s

trim buttons.

1. Deviation in yaw. If the XView displays a natural

tendency to rotate clockwise, use the rudder trim

to correct this by pressing the left side of the

button. If the XView displays a natural tendency to

rotate anticlockwise, use the rudder trim to correct

this by pressing the right side of the button.

(Mode 2 Transmitter Shown)

2. Deviation in roll. If the XView displays a natural

tendency to move sideways to the left, use the

aileron trim to correct this by pressing the right

side of the button. If the XView displays a natural

tendency to move sideways to the right, use the

aileron trim to correct this by pressing the left side

of the button.

(Mode 2 Transmitter Shown)

3. Deviation in pitch. If the XView displays a natural

tendency to move forward, use the elevator trim to

correct this by pressing the bottom of the button.

If the XView displays a natural tendency to move

backward, use the elevator trim to correct this by

pressing the top of the button.

(Mode 2 Transmitter Shown)