User Manual

QUICK-START GUIDE
Full manual available to download from: www.Ares-RC.comFull manual available to download from: www.Ares-RC.com
1
Carefully remove the transit tape
and the foam retainers, gently lift
the components from the box and
ensure you have the following:
• 100% Factory assembled SPAD
S.XIII
• 70mAh 3.7V 1S Li-Po battery
• USB charger
2
Plug the supplied USB charger into
a suitable port noting that the LED
on the charger will ash red when
connected.
This half of the Quick Start Guide is written for the PTF (Pair to Fly) version of the SPAD
S.XIII. A full instruction manual is available to download from www.ares-rc.com.
3
Connect the battery to the charge
lead making sure to align the red
dots. Note that the ashing LED will
now glow solid bright red. Note that
a discharged battery will be charged
in 30 to 50 minutes and can be
seen to be fully charged when the
red LED dims signicantly. When this
happens the battery is ready to use
and can be disconnected from the charge lead.
4
Pair your chosen Hitec air
transmitter to the SPAD’s 3-in-1
control unit. Start by following the
pair/binding instructions supplied
with your Hitec air transmitter
making sure to select the Minima
receiver option when prompted.
Having put your transmitter into
pair/bind mode, connect the battery to your SPAD to power it ON. Pairing will
now commence, the process being complete when the rudder and elevator
move back and forth briey. Follow your transmitter’s instruction manual for
guidance on exiting the pairing process.
PTF