User Manual

QUICK-START GUIDE
Full manual available to download from: www.Ares-RC.comFull manual available to download from: www.Ares-RC.com
5
A fully discharged battery will be
charged in under an hour, at which
point the yellow light will stop
glowing. The battery is now ready to
use and can be disconnected from
the charge lead.
6
Pull the throttle stick back to its
lowest point and switch ON the
transmitter.
7
Remove the magnetic battery
hatch cover from the underside of
the model. Connect the lead to the
battery (making sure to align the
red dots as before) and use the
magnet retainer to clip the battery
in position. Replace the battery
hatch cover.
8
Having plugged in the Li-Po the rudder and
elevator control surfaces will move, indicating
that the 3-in-1 control unit has initialized and
that the motor is armed. Raising the throttle
stick will now start the motor. In the unlikely
event that the initialization process fails,
please see the pairing instructions that follow
these steps.
You should now check the control surfaces, as detailed overleaf, noting that instructions
for servo reversing are available in the full online instruction manual at www.ares-rc.com.
On this 3 channel airplane the rudder function is controlled by the aileron stick on the
transmitter.