AZSA1500 Ares Sopwith Pup RTF Manual

9
• When the battery is connected to the charge lead securely, and with the
proper polarity, the ‘CHG’ (charge) LED indicator on the transmitter will
glow solid yellow. The battery will be charging anytime the LED indicator is
glowing solid yellow and whether or not the transmitter is powered on.
• The 100mA charger will charge the 70mA battery in less than 1 hour. When
the battery is fully charged the LED indicator will stop glowing entirely,
whereupon you can remove the battery from the charge lead / connector as
it is now fully charged and ready for use.
NOTE: The LiPo battery included with each new model will arrive partially
charged. For this reason the initial charge may only take 30 – 45 minutes.
3. Switching on. Pull the throttle stick back to its lowest position and switch on
the transmitter, noting that the LED will glow solid blue and the transmitter
will emit three short beeps.
4. Install the ight battery. Install the fully charged 70mAh LiPo battery in
your Sopwith Pup by plugging the ultra-micro connector on the battery to
the lead extending from the bottom of the aircraft. Make sure, once again,
to match the red circles on the connectors to assure correct polarity.The
battery attaches to the airplane with a magnet. So, simply place the battery
in position with the plug end facing the tail. Slide the front of the battery
into the notch to ensure that the airplane’s Centre of Gravity is correct.