AZSA1500 Ares Sopwith Pup RTF Manual
14
2. Connect the ight battery to the 3-in-1 control unit.
3. Power the transmitter OFF and back ON again noting that the
transmitter’s LED will light solid blue.
4. The pairing process is complete when the rudder and elevator cycle back
and forth briey.
Transmitter Factory Reset
If you wish to return your Hitec Red 4-channel transmitter to factory default
settings (all trims centered and all servo reverse settings reset), you can do
this very easily:
1. Power the transmitter ON.
2. Press and hold the Channel 4 right-hand trim button whilst
simultaneously pressing the Channel 3 trim button (+ or -).
3. The buzzer will emit a long beep signalling that the factory reset is
complete.
Replacement Parts
AZSB1803 .............70mAh 1-cell/1S 3.7V 10C LiPo with ultra-micro connector
AZSA1806..............3-channel, 3-in-1 control unit – receiver/2 servos/ESC
AZS1509 ................Motor with pinion gear
AZS1511 ................Gearbox with shaft
AZS1512 ................Propeller shaft with gear
AZS1513 ................Wing set with decals
AZS1514 ................Tail set with decals
AZS1515 ................Fuselage with decals
AZS1516 ................Main landing gear set
AZS1517 ................Pushrod set
AZS1518 ................Wing strut set
AZS1520 ................Decal set
AZSP1522 .............4.7 x 2.75 micro scale propeller
AZSA1838M1 ........Micro 4-channel airplane Tx with 100mA charger (Mode 1)
AZSA1838..............Micro 4-channel airplane Tx with 100mA charger (Mode 2)
AZS1107 ................Replacement rotary servo mechanics