AZSA1500 Ares Sopwith Pup RTF Manual

13
Servo Reversing
The Hitec Red 4-channel transmitter features control/servo reversing
functionality for the rudder, elevator, throttle and aileron channels. The
control/servo directions were set correctly at the factory for your Sopwith
Pup, however if any of the controls are operating in the wrong direction or if
you make use of the electronics in other models at a later date, follow these
steps to change the control/servo directions as required.
Rudder channel control/servo reversing
Press and hold the right rudder trim button, then press the left rudder
trim button. Release both buttons and the control / servo direction will be
reversed.
Elevator channel control/servo reversing
Press and hold the right rudder trim button, then press the down elevator
(top) trim button. Release both buttons and the control / servo direction will
be reversed.
Aileron channel control/servo reversing
Press and hold the right rudder trim button, then press the right aileron
trim button. Release both buttons and the control / servo direction will be
reversed.
Transmitter Pairing
Pairing is the process of programming the receiver in the 3-in-1 control unit
to recognize the Globally Unique Identier (GUID) code of a single specic
transmitter. If you ever nd it necessary to replace the transmitter or the 3-in-
1 control unit, it will be necessary for you to re-pair the two units (as detailed
below) for proper operation.
1. Press and hold the Channel 4 right-hand trim button and simultaneously
switch ON the transmitter. A ashing red LED will indicate that the
transmitter is in pairing mode.