User Manual

QUICK-START GUIDE
Full manual available to download from: www.Ares-RC.comFull manual available to download from: www.Ares-RC.com
11
Remove the baery hatch, slide the
Li- Po into the front secon of the
fuselage and secure it to the baery
mounng plaorm using the hook
and loop tape supplied.
12
Remove the transmier baery
cover (RTF version only) and insert
four AA alkaline cells taking care to
observe the correct polarity.
13
Switch ON your transmier, ensure
the LED is lit solid red, then center
all the trim levers and move the
throle sck to the low posion
(RTF version only). PTF owners
should now pair their Hitec red
enabled transmier using the guide
at the back of this Quick Start Guide.
14
Connect the baery to the ESC, the servos will
become operaonal. Plug in the LEDs to the balance
connector of the ight baery. Stow the leads
within the fuselage and replace the baery hatch.
The servos are acve but the motor is not armed
at this point. In the unlikely event that the servos
do not operate, see the PAIRING instrucons at the
back of this guide.
15
With the control surfaces centered,
connect the elevator and rudder
clevises to the outer hole of each
control horn nong that you may
have to screw the clevis in or out
to ensure that the control surface
remains in the neutral posion.
16
If you need to adjust a clevis, grasp
the pushrod with a pair of needle-
nose pliers and screw the clevis in or
out as required.
17
Check that the control surfaces
operate in the correct direcon.
With the model in front of you,
facing away, move the rudder sck
to the right and check that the
rudder moves right in response. Le
rudder sck will move the rudder to
the le.
18
Pull the elevator sck back and
check that the elevator moves in an
upward direcon. Push the elevator
sck forward and check that the
elevator moves in a downward
direcon.
19
20
Place the wing into posion on top
of the fuselage and retain with at
least 4 rubber bands but no more
than 6 rubber bands. Install the
bands as shown in the photo to the
right.
Plug the two LED connectors into
the LED Y-connector. Make sure to
match the wire colors for correct
polarity.