User Manual
QUICK-START GUIDE
Full manual available to download from: www.Ares-RC.comFull manual available to download from: www.Ares-RC.com
1
Remove the components from the box
and ensure you have the following parts:
Fuselage assembly, a le- and right- hand
wing panel, stabilizer, n and rudder,
landing gear, 2.4GHz 6-channel transmier
(included in RTF version, required for PTF),
LiPo balance charger, mains adaptor, 2- cell
LiPo baery, spinner, propeller, screwdriver.
2
Insert the vercal n mounng legs
through the holes in the stabilizer
and then place the unit on the top of
the rear fuselage.
3
Invert the fuselage and insert the
plasc connector into the holes in
the fuselage. Make sure to capture
the plasc bracket for the tailwheel
under the plasc connector.
4
Insert the two 2mm x 8mm machine
screws into the holes in the plasc
connector and ghten with the
supplied screwdriver. Install one
screw to retain the tailwheel
bracket.
5
Slide the two wing halves together
to test t.
Place the charger on a at, heat resistant surface
with a good airow all around. Connect the supplied
2S 1000mAh Li- Po baery to the charger using the
white three pin balance plug, ensuring the correct
orientaon of the plug. The red and green ‘Charger’
LEDs will light indicang that the baery is charging.
When fully charged the red LED will remain glowing
the green will be out, whereupon the baery can be
disconnected.
6
Peel the backing paper from the
front and rear plasc reinforcement
plates.
7
Slide the wings together and press
the plasc plates down to retain.
8
Insert main landing gear into slot
on boom of fuselage. Retain with
two washer head machine screws in
holes provided.
9
10
Read and fully understand the Li- Po care and safety
precauons in the full online manual at
www.ares- rc.com and never leave Li- Po baeries
unaended while charging. Plug the mains power
adaptor into a wall socket and connect the charger to
the power adaptor using the circular DC socket. Note
that the red LED ‘Power’ indicator on the charger will
light.