User Manual

Full manual available to download from: www.Ares-RC.com

Transmitter Pairing

Having followed Steps 1 to 19, in the unlikely event that your Crusader does not operate

please follow the 4 stage pairing process detailed here:

If you’re completing the PTF version of the Crusader using a Hitec air transmitter, follow your

transmitter’s guide to pairing and power ON the receiver when prompted, noting that the

KA-6 receiver is an autopair receiver and does not require that you press a pair/link button.

PAIRING GUIDE

If already tted, remove the

Crusader’s propeller. Place the

transmitter and receiver (you can

leave this in the model) within

200cm of each other (but not

less than 45cm) then power the

transmitter ON.

Power the receiver ON by

connecting the LiPo battery to the

ESC, as before. The Receiver’s LED

will initially ash red / blue, then

change to fast-ashing red. For

initial pairing the receiver must be

powered on within 5 seconds of the

transmitter. Once paired this time

constraint is no longer necessary.

Pairing will be complete when the

receiver’s fast-ashing red LED

turns solid red. This usually works

without issue, however if you are

attempting to operate multiple

aircraft at the same time be sure

that you only turn one transmitter

and aircraft on at a time, waiting for

the two to pair before moving to the

next. If a mis-pair occurs simply turn off both units and begin the process again.

You should now have full control of

your Crusader. Return to Step 20 of

this guide to complete the set-up of

your model.

45–200cm

LED