Instruction manual

22

Parts/ToolsRequired:

 Propeller(2‐bladeor4‐blade)

 Spinnerbackplate(for2‐blade

or4‐blade)

 Spinnercap/cone

 3mmflatwasher;1pc

 3mmhex‘lock’nut;1pc(for4‐

blade)or2pcs(for2‐blade)

 3mm‘flanged’nut;1pc(for4‐blade)

 Pliers,

anadjustablewrenchand/or

a5.5mmsocket/wrench

Toinstallthe4‐bladepropellerstartbythreadingthe3mm‘flanged’nutontothe

threadedportionofthemotorshaft,withthe‘flange’orientedtowardtheendofthe

shaft,untilitstopsattheendofthethreads.Tightenthisnut

inplace(donotover‐

tighten!)theninstallthepropellerontheshaftandslideitagainstthenut.



Toinstallthe2‐bladepropellerstartbythreadingthefirst(rear)3mmhex‘lock’nut

ontothethreadedportionofthemotorshaft,withthenyloninsert/’lock’oriented

towardthe

BACKoftheairplane,untilitstopsattheendofthethreads.Tightenthis

nutinplace(donotover‐tighten!)theninstallthepropellerontheshaftandrotateitas

necessaryuntilitlinesupwith,slidesoverandfully‘engages’thenut.



Next,installthe

appropriatespinnerbackplateontheshaftandoverthepropeller.

Slidetheflatwasherontotheshaftandagainstthespinnerbackplatethenthreadthe

(front)hex‘lock’nut(withthenyloninsert/’lock’orientedawayfromthewasher)onto

theshaftandtightenitaccordingly(donotover‐tighten!).

IMPORTANTNOTE:Youwill

needtousepliers(narrowneedlenose,orevenhemostats,willworkbest)to

carefullyholdthemotorshaftbehindthepropellerwhileusinganadjustablewrench

or5.5mmsocket/wrenchtotightenthehexnutinfrontofthepropeller/spinnerback

plate.