Instruction manual

19
Withthetrimscenteredcarefullyspreadopeneach‘clevis’(thewhitecolorplasticpart
installedonthethreadedendofthemetalpushrod)soyoucaninsertthepininthe
OUTERMOSTholeoneachcontrolhorn.Itmaybehelpfultoinsertaflatblade
screwdriver(notincluded)intothe
clevisthentocarefully‘twist’ituntilitdisengages
thepinfromtheholeintheclevis.Also,itisnotnecessaryto‘snap’theclevisback
togetheruntilthecenteringadjustmentsarecomplete.



Afterconnectingtheclevisestothecontrolhornsviewtheverticalstabilizer/tailand
rudderfromdirectlyabove.Theruddershouldbe‘inline’withtheverticaltailwhenit’s
properly‘centered’.However,iftherudderisangledofftotherightorleftyoucan
adjustthelength/positionofthe
pushrod/clevissothesurfaceiscentered
‘mechanically’whiletherudderchanneltrimiscentered.



Iftherudderisangledofftotherightcarefullyremovetheclevisfromthecontrolhorn
andscrewit‘in’(clockwise)onehalftoonefullturntheninsertthepinbackintothe
outermostholeinthecontrolhorn.Or,iftherudderisangledofftothe
leftcarefully
removetheclevisfromthecontrolhornandscrewit‘out’(counter‐clockwise)onehalf
toonefullturntheninsertthepinbackintotheoutermostholeinthecontrolhorn.
Viewtheverticaltailandrudderfromdirectlyaboveagainandcontinueadjustingthe
length/positionof
thepushrod/clevisuntiltherudderisproperlycentered.