Instruction manual

15


WiththehorizontaltailproperlyalignedslidethetwoT2x25mm‘button’headscrewsinto
theopenings/slotsinthebottomofthefuselage.Thescrewsshouldpassthroughthe
horizontaltailandintotheopeningsoftheplasticmountlocatedintheupperpartofthe
fuselage(abovethe
openingforthehorizontaltail).Adjustthepositionofthehorizontaltail
slightlyasneededuntilthescrewsengagetheplasticmountthentightenthemsecurely.Be
carefulwhentighteningthesescrewsbecausetighteningthemtoomuchcanstrip/breakthe
plasticmountand/ordamagethefuselage/tails.Also,ensurethatthe
tailisproperly
centeredandalignedaftertighteningthescrews.



Thehorizontaltail/stabilizerisnowinstalled,andbesuretoproceedthroughthefollowing
sectionsofthemanualbeforeattachingtheclevisestotherudderandelevatorcontrolhorns.






