Instruction manual

14



Parts/ToolsRequired:
 Wing
 Fuselage
 M3x30mm‘button’headscrew;1pc
 Phillipsscrewdriver

Before attaching the wing to the fuselage plug
the 3‐wire lead from the aileron servo into the
aileron (AILE) channel of the receiver (or into an
optional ‘servo extension’ already connected to
the
 aileron channel of the receiver). Then,
carefully slide the trailing  edge of the wing into
the space between the ‘radiator scoop’ and the
‘wing saddle’ area of the fuselage. And before
pushing the wing against the wing saddle/
fuselage be sure that the 3‐wire lead from the
aileron servo
is ‘tucked’ securely inside of the
fuselage and isnot in theway ofthe rudder and
elevatorservoarms.UseanM3x30mm‘button’
headscrewtosecurethewingtothefuselage.





Parts/ToolsRequired:
 Fuselage
 Horizontaltail/stabilizer
 T2x25mm‘button’head
screw;2pcs
 Phillipsscrewdriver

Toinstallthehorizontalstabilizer/tail,startbyslidingitthroughtheopeningattherearofthe
fuselage.Thesideofthehorizontaltailwiththecarbonfibersparsshouldbeoriented
downward(towardthebottomofthefuselage),andbecausetheelevatorcontrolhornis

locatedontherightsideyoushouldslidetheleftsideofthehorizontaltailthroughtheright
sideoftheopeninginthefuselage(whenviewingtheairplanefrombehind).Then,alignthe
horizontaltailsoit’s‘centered’inandagainstthefrontoftheopeninginthefuselage.

Attachin
g
the Win
g
Installin
g
the Horizontal Stabilizer/Tail