Instruction manual

• When the baery is connected to the charger securely and with the proper polarity the LED
indicator will glow solid red. The baery will be charging anyme the LED indicator is glowing
solid red.
• It will take approximately 1.0–1.5 hours to fully charge a mostly or fully discharged
(not over-discharged) baery. And when the baery is fully charged the LED indicator will
change to glow solid green. When the LED is glowing solid green you can disconnect the
baery from the charger as it is now fully charged and ready for use.
NOTE: The LiPo baery included with your model will arrive parally charged. For this reason the
inial charge may only take approximately 30–45 minutes.
NOTE: It’s safer and beer for the longevity of the baery to store it only parally charged for any
length of me. Storing the baery at approximately 50% charge (which is approximately 3.85V per
cell) is typically best, however, it will take some careful management of the charge me and the use
of a volt meter to achieve this voltage. If you have the equipment and skills to achieve the 50% charge
level for storage it is recommended. If not, simply be sure to not store the baery fully charged
whenever possible. In fact, as long as the baery will be stored at approximately room temperature
and for no more than a few weeks before the next use, it may be best to store the baery in the
discharged state aer the last flight (as long as the baery was not over-discharged on the last flight).
8