Instruction manual

LiPo Battery Warnings and Usage Guidelines

IMPORTANT NOTE: Lithium Polymer baeries are signiﬁcantly more volale than the alkaline, NiCd or

NiMH baeries also used in RC applicaons. All instrucons and warnings must be followed exactly to

prevent property damage and/or personal injury as mishandling of LiPo baeries can result in ﬁre.

By handling, charging or using the included LiPo baery you assume all risks associated with LiPo

baeries. If you do not agree with these condions please return the complete product in new, unused

condion to the place of purchase immediately.

And although the 500mAh 1-Cell/1S 3.7V 15C LiPo Baery (AZSH1255) included with the RTF version

Chronos FP 110 is intended to be charged safely using the included 1-Cell/1S 3.7V LiPo, 0.5A 110-240V

AC Charger (AZSH1254) you must read the following safety instrucons and warnings before handling,

charging or using the LiPo baery.

• You must charge the LiPo baery in a safe area away from ﬂammable materials.

• Never charge the LiPo baery unaended at any me. When charging the baery you should

always remain in constant observaon to monitor the charging process and react immediately

to any potenal problems that may occur.

• Aer ﬂying/discharging the baery you must allow it to cool to ambient/room temperature

before recharging.

• To charge the LiPo baery you must use only the included 1-Cell/1S 3.7V LiPo, 0.5A 110-240V AC

Charger (AZSH1254) or a suitably compable LiPo baery charger. Failure to do so may result in

a ﬁre causing property damage and/or personal injury. DO NOT use a NiCd or NiMH charger.

• If at any me during the charge or discharge process the baery begins to balloon or swell,

disconnue charging or discharging immediately. Quickly and safely disconnect the baery,

then place it in a safe, open area away from ﬂammable materials to observe for at least 15

minutes. Connuing to charge or discharge a baery that has begun to balloon or swell can

result in a ﬁre. A baery that has ballooned or swollen even a small amount must be removed

from service completely.

• Store the baery at room temperature, approximately 68–77° Fahrenheit (F), and in a dry area

for best results.

• When transporng or temporarily storing the baery, the temperature range should be from

approximately 40–100°F. Do not store the baery or model in a hot garage, car or direct

sunlight whenever possible. If stored in a hot garage or car the baery can be damaged or even

catch ﬁre.