Instruction manual

Installing and Removing the LiPo Flight Battery
Aer the LiPo baery has been fully charged it’s ready to be installed in the helicopter. To install
the baery in the helicopter start by removing the canopy. Next, with the wire leads and connector
of the baery oriented so they point forward (away from the 4-in-1 control unit), place the baery
in the baery holder so the hook-and-loop material on the baery and holder make contact. Then
secure the baery in the holder by wrapping the included hook-and-loop strap around the baery
and holder.
To remove the LiPo flight baery (aer carefully disconnecng it from the 4-in-1 control unit) start
by removing the canopy and the hook-and-loop strap. Then remove it from the baery
holder/helicopter completely.
Control Unit Initialization, Arming and Motor Control Test
The Chronos FP 110 is equipped with a compact and advanced 4-in-1 control unit. The control unit is a
lightweight combinaon of 2.4GHz receiver, two electronic speed controls (ESCs), a mixer and gyro.
The control unit is also equipped with LEDs that provide various indicaons.
The following checklist includes the steps you must follow to ensure proper inializaon, arming and
operaon of the control unit:
18