User manual Crossfire

Hitec/Futaba

• Red/Black/White – Aileron CH1

• Red – Elevator/CH2

• White – Throttle/CH3

• Green – Rudder/CH4

• Blue – Auxiliary 1/CH5 (normal gyro/self level gyro)

• Yellow – Auxiliary 2/CH6 (lost model beeper)

Spektrum/JR

• Red/Black/White – Throttle/CH1

• Red – Aileron/CH2

• White – Elevator/CH3

• Green – Rudder/CH4

• Blue – Auxiliary 1/CH5 (normal gyro/self level gyro)

• Yellow – Auxiliary 2/CH6 (lost model beeper)

5. Reciever Connection. Plug the wires into the respective sockets on your

receiver noting that the single-pin connectors should be attached to the

‘signal’ pin, usually reserved for the yellow, orange or white wire.

6. Receiver installation. Secure your receiver to the upper frame using hook

and loop tape and secure the antenna wire(s). Note that only low-prole end

pin receivers are suitable for the Crossre due to the close proximity of the

fuselage shell when tted.