User manual Crossfire

Set-Up & Programming

1. Remove the canopy. Withdraw the rear body clip and gently ease the

canopy from the airframe by gently unclipping the fairings from the

outrigger supports and sliding the canopy forward, over the camera.

2. Canopy protection. For transport the canopy is protected by a thin shrink

wrap lm covering. Remove this to appreciate the full color luster of your

Crossre’s paintwork.

3. Transmitter programming/preparation. Pair your chosen transmitter

and receiver by following the pairing/binding procedure noted in your

transmitter’s instruction manual. Having done this, ensure that:

• The model memory you’ve chosen for your Crossre is set to ACRO mode.

• The wing type is set to single servo aileron control.

• All trims are centered.

• End Point Adjustment (ATV) is set to 100% on all channels.

• All sub trims are centered.

4. Wiring identication. Locate the receiver wiring loom on the left-hand side

of the electronics board and note the location ID for each wire using the

guide below: