User manual Crossfire

33. Check gyro compensation at zero throttle. With the throttle stick at its

lowest position, tilt the Crossre from side to side and check that the

motors remain inactive. If the motors rotate when the quad is tilted, this

is clear evidence that gyro compensation at zero throttle is still active and

that Step 28 will need to be repeated.

34. Disarming the motors. To disarm / disable the motor operation, move

the throttle stick to the bottom left-hand corner of the gimbal (the default

position for Mode 2 transmitters) and hold until two short beeps are

heard.

35. Propeller identication. Having conrmed that all works as it should and

that the motors rotate correctly, disconnect the battery and switch OFF

your transmitter. Identify the propellers noting that two of the four have

a right-hand rotation (denoted by the letter R alongside the dimension

embossed on the root section of the blade). R designated propellers

should be installed on motors A and C and tted with a black (left-hand

thread) prop nut. The remaining left-hand rotation propellers should be

secured to motors B and D.