User manual Crossfire

22
Flight Preparation
29. Re-t the canopy. Disconnect the cloverleaf antenna using the 8mm
wrench, ret the fuselage molding using the rear body clip, then re-
connect the antenna.
30. Battery installation. Insert the fully charged 3s 2200mAh Li-Po and
secure it with the hook and loop strap. As the LiPo is installed from under
the Crossre, the fuselage molding does not need to be removed.
31. Arming the motors. WITH THE PROPELLERS STILL REMOVED, switch your
transmitter ON and connect the Crossre’s battery. A series of beeps will
be heard conrming that the quad is ready to arm. Place the Crossre
on a level surface and arm the motors by moving the throttle stick to
the bottom right corner of the gimbal (the default position for Mode 2
transmitters) and holding until a series of beeps (one full and one half
beep) is heard.
32. Re-check the motor operation. Check the rotation direction of the motors
by gently increasing the throttle and viewing from above.