User manual Crossfire
20
22. ESC calibration. Select ‘Motors’ from the menu bar on the left-hand side
of the Cleanight interface and check / adjust the following:
▪ If you’ve already attached the propellers to your Crossre, REMOVE THEM NOW.
▪ Read the ‘Motor Test Mode Notice’ and conrm that you’ve removed the
propellers by pressing the disclaimer button to enable motor control.
▪ Drag the ‘Master’ slider control to the top of its travel.
▪ Ensure your transmitter is powered ON and pull the throttle stick back to close
the throttle.
▪ Install the charged 3S 2200mAh LiPo battery into your Crossre and plug it in
(see Step 30). On connecting the LiPo the Flight Control Board will emit a series
of beeps.
▪ Drag the ‘Master’ slider control back to zero. A series of short beeps will conrm
that ESC calibration is now complete.
▪ Disconnect the LiPo battery.
▪ Disconnect the mini USB from the Flight Control Board.
▪ Repower the board by re-connecting the mini USB.
23. Motor testing. Select ‘Motors’ from the menu bar on the left-hand side of
the Cleanight interface and check them using the following method:
▪ Install the charged 3S 2200mAh LiPo battery into your Crossre and plug it in
once more.
▪ Conrm that the propellers are still removed by pressing the disclaimer button to
enable motor control.
▪ Use the motor sliders (1 to 4) to individually check the rotation direction of the
four motors in accordance with the graphic in the top left corner of the screen.
▪ Disconnect the LiPo battery.