User manual Crossfire
19
Allow the roll, pitch and yaw sticks on your transmitter to ‘centre’, then
manually and precisely centre the throttle stick. Precisely centre the roll,
pitch and yaw trims, then reduce the throttle trim to its lowest position.
Now use the bar graph to check that roll, pitch, yaw and throttle are set to
1500, i.e. their centre points. If any of the values are higher or lower than
1500, use your transmitter’s sub trim function to adjust.
18. Establish a switched mode function for gyro stabilized ight. Select
‘Modes’ from the menu bar on the left-hand side of the Cleanight
interface and check / adjust the following:
▪ Under the heading ‘HORIZON’ select the AUX 1 channel from the drop down
menu.
▪ In step 4 or 5 you will already have connected the AUX 1 wire to the Channel
5 socket on your receiver. So, in the programming section of your transmitter,
assign Channel 5 to a two-position switch of your choice.
▪ The programming can be veried as correct when the HORIZON icon turns green
with the Channel 5 switch in the ON position. This, then, is your gyro stabilised
ight condition.
▪ Set the range to: Min: 1400; Max: 2100.
▪ Click ‘Save’.
19. Congure adjustment switches. No changes need to be made under
the ‘Adjustments’ heading in the menu bar on the left-hand side of the
Cleanight interface.
20. Congure servos. No changes need to be made under the ‘Servos’
heading in the menu bar on the left-hand side of the Cleanight
interface.
21. Congure GPS. No changes need to be made under the ‘GPS’ heading in
the menu bar on the left-hand side of the Cleanight interface.