Installation manual

Arecont Vision MegaBall™ Installation Manual
7 | Page
Camera Installation:
21. Install the AV100 application manager
Software. (Image 13, found on the CD).
22. Run the AV100 application manager by
double clicking on the icon shown below.
(Image 14, found on your desktop).
Image 13 Image 14
23. Select “Run” next to “Setup Cameras” from
the AV100 application manager as shown in
Image 15 and wait for “Arecont Vision
Camera Installer” window to appear as shown
in Image 16.
Image 15
24. Click “Mode” tab to select desired install mode
on the Arecont Vision Camera Installer as
shown in Image 16.
NOTE 1: Basic Mode (default setting): software will
automatically discover and change / assign IP
address to match PC subnet.
NOTE 2: Advanced Mode: software will
automatically discover but allow manual update of
the IP address. See “AV100 Installation Manual”
(found on the CD) for details on Advanced Mode.
NOTE3: User can verify camera model number and
FW version of all cameras as shown in Image 16.
Image 16
25. For basic mode, select “Install Cameras” on
the Arecont Vision Camera Installer as shown
in Image 16.
26. Confirm that all the cameras connected to the
network switch appear in the upper window.
27. Repeat Step 25 if all of the cameras do not
appear in the upper window.
CAUTION: If the software does not find a camera,
the software utility may be blocked by the anti-virus
or Windows
®
NOTE : Double click the camera model on the
Camera Installer as shown in Image 17 to access
the camera web interface. See “AV Camera Web
Page User Manual” (found on the CD) for details on
the web interface.
firewall. Before turning them off,
please consult your IT manager.